3
Controller Setup
 return_top
How to Hold the Wii Remote
and Nunchuk
Preparing the Wii Remote
and Nunchuk
  1. Feed the wrist strap cord through the connector hook on the Nunchuk plug as shown in the diagram.
  1. With the wrist strap cord fed through the connector hook, insert the Nunchuk plug into the external extension connector on the Wii Remote.
  1. Put your hand through the wrist strap, grasp the Wii Remote firmly, and adjust the strap lock.

Note: If you strap lock has a lock lever, press the lock lever down until you hear a click. This will prevent the strap lock from loosening.

  1. Hold the Nunchuk with your other hand.
The Nunchuk Neutral
Position Reset Feature
If a Nunchuk’s Control Stick is off from the “neutral position” (*) and you cannot operate it as normal, do the following:
Take your thumb off the Control Stick and simultaneously hold down , , and on the Wii Remote for approximately three seconds.

Neutral position for the Nunchuk

* The “neutral position” is where no control sticks are tilted and no buttons are being pressed. If any control stick is tilted or any buttons are being pressed when the power is turned on for the Wii console, that state will be set as the neutral position, and the control sticks and buttons will not operate normally.
back next