4. Controller Setup

Controller Setup


	How to Hold the Wii Remote and Nunchuk


	Preparing the Wii Remote and Nunchuk

Feed the wrist strap cord through the connector hook on the Nunchuk plug as shown in the diagram.

With the wrist strap cord fed through the connector hook, insert the Nunchuk plug into the External Extension Connector on the Wii Remote.

Put your hand through the wrist strap, grasp the Wii Remote firmly, and adjust the strap lock.

Note: If your strap lock has a lock lever, press the lock lever down until you hear a click. This will prevent the strap lock from loosening.

Hold the Nunchuk with your other hand.


	The Nunchuk Neutral Position Reset Feature

If a Nunchuk's Control Stick is off from neutral position* and you cannot operate it as normal, do the following:


	Take your thumb off the Control Stick and simultaneously hold down , , , and on the Wii Remote for approximately three seconds.

[Neutral Position]

* The position in which the Control Stick is not tilted is called the "neutral position." If the Control Stick is tilted when the power is turned on for the Wii console, that state will be set as the neutral position, and the Control Stick will not operate normally.